Simple, Safe, Reliable Health Tests despatched the same day.

Digital Alcohol Meter Test Instructions

OPERATION

1. Turn on the PWR On/Off switch.

The detector will start the countdown from 200 to 000 on the display window.
This is a “Warm-up “process to make the sensor and circuit be ready for testing.

2. When you hear beep sound & green lighting is on READY, please blow steadily into thepipe until you would hear the “Beep” sound again. Stop blowing.

In this stage, if you don’t blow within 30 seconds, it automatically shows OFF display for turn-off.
In case you drink quite a little (If actual concentration would be below 0.01% BAC/0.05mg/l BrAC), it may not be activated. However it shows still 0.00% and you’re said to be in safe range.

3. Then, after the red and green lights are simultaneously flickering for 4 seconds, the test result will be displayed by 3 digits for 15 seconds.

If the BAC/BrAC data would be over 0.05% /0.25mg/l (default setting) respectively. Red WARN lamp will be flickering along with “Alarm” sound.

4.   Finally it shows “OFF” for turn-off

5.   For the successive testing, try again from No.1 to No.3.

6.   Space tests at least 2 minutes apart.

WARNING

1. After drinking, it is recommended to test after 20 min.

It is because it takes 20 min, approximately for alcohol to be absorbed into the blood from the digestive organs, and residual alcohol remaining in the mouth takes this long to dissipate.

2.   Avoid testing under strong wind or in the closed room with contaminated air.

3.   When the “BAT LOW” lamp is on, it is advisable to replace 9V alkaline battery.

4.   Do not blow cigarette smoke or liquid into the instrument. It will damage the sensor. Wait 1 minute after smoking before a test.

5.   Although the Digital Alcohol detector analyzes blood alcohol concentration accurately, do not use Digital Alcohol detector as a tool to drink and drive.

6.   Keep it under 32-104 (F) and out of the reach of children

7.   In normal use, the Digital Alcohol detector requires re- calibration every 6-12 months to obtain accurate results. Discuss this with Simplicity Health for re-calibration.

8.   Do not leave Digital Alcohol detector car adaptor connected with the cigar lighter.